Euro spec tail light install and coding changes

[SWFLf10]

I just recently swapped my rear tail lights with the euro spec ones (amber signal instead of the US standard red) and I found that the brake lights were linked to the signal LEDs. I did a little research and some trial and error and found these two settings have to be changed in the FRM module. I used E-SYS and Bimmer Utility to make the changes. Hope this helps someone else in the future!

LAMP MAP PARA SATZ 05
BV_F010 _wert_01_BL_mit_SL2 (17,07,04,64)

LAMP MAP PARA SATZ 06
BV_F010 _wert_01_BL_mit_SL2 (18,08,04,64)

[vaio23]

Can you post some before and after pics

[RJV3]

+1...would love to see how this mod turned out.

[SWFLf10]

I'll have to take a few pics. Currently traveling today and tomorrow. I'll see if I can get a few tomorrow morning before I head out.

[SWFLf10]

Here is the best I could get quickly this morning. It's not super noticeable that it's amber when it's not on. Looks very close to the stock red signals when off.