Can’t clear codes 2015 F12

[Ttuite]

Hi,
My passenger side door window in inop. Scanned car with BimmerLink. Cleared all codes, cleared memory, and cleared permanent codes. 2 codes keep appearing and are active.

Central gateway module 801C20 Central fault memory full. Error present and stored.

Drivers side footwell module. 030095 Fh NG:invalid characteristics, no standardization available. Error present and stored.

What can I do about these faults?

Thanks in advance.

[Ttuite]

Originally Posted by Ttuite

Hi,
My passenger side door window in inop. Scanned car with BimmerLink. Cleared all codes, cleared memory, and cleared permanent codes. 2 codes keep appearing and are active.

Central gateway module 801C20 Central fault memory full. Error present and stored.

Drivers side footwell module. 030095 Fh NG:invalid characteristics, no standardization available. Error present and stored.

What can I do about these faults?

Thanks in advance.

Was hoping for some information. Is there a better place to post this question?

[arucano]

Originally Posted by Ttuite

Hi,


Central gateway module 801C20 Central fault memory full. Error present and stored.


Thanks in advance.

Central fault memory

The task assigned to this subfunction is the central storage of Check Control messages, in addition to local fault memory units on individual control units. The Central Gateway Module (ZGM) is the master for this function and is also known as the diagnosis master.

[Ttuite]

Originally Posted by arucano

Central fault memory

The task assigned to this subfunction is the central storage of Check Control messages, in addition to local fault memory units on individual control units. The Central Gateway Module (ZGM) is the master for this function and is also known as the diagnosis master.

Any way to clear the storage memory?