07-04-2021, 01:12 PM | #1 |
Private
135
Rep 84
Posts |
Can’t clear codes 2015 F12
Hi,
My passenger side door window in inop. Scanned car with BimmerLink. Cleared all codes, cleared memory, and cleared permanent codes. 2 codes keep appearing and are active. Central gateway module 801C20 Central fault memory full. Error present and stored. Drivers side footwell module. 030095 Fh NG:invalid characteristics, no standardization available. Error present and stored. What can I do about these faults? Thanks in advance. |
07-06-2021, 03:54 PM | #2 | |
Private
135
Rep 84
Posts |
Quote:
Was hoping for some information. Is there a better place to post this question? |
|
Appreciate
0
|
07-06-2021, 04:50 PM | #3 | |
Captain
252
Rep 631
Posts
Drives: 2014 M6 Grand Coupe CP
Join Date: May 2017
Location: Kingwood TX
|
Quote:
The task assigned to this subfunction is the central storage of Check Control messages, in addition to local fault memory units on individual control units. The Central Gateway Module (ZGM) is the master for this function and is also known as the diagnosis master.
__________________
F06 M6 Grand Coupe CP
Sapphire Black Metallic The drive is the destination |
|
Appreciate
0
|
07-06-2021, 09:51 PM | #4 | |
Private
135
Rep 84
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|