11-16-2020, 03:30 PM | #1 |
New Member
1
Rep 9
Posts |
Long list of trouble codes (using BimmerLink)
I installed BimmerLink on my phone to read any issues from my 2013 640i GC. I am using Veepeak OBD BLE bluetooth adapter. Though there are no permanent errors, the info memory is full of errors and they keep coming back even after I clear those. Some of those don't even clear when I remove them. Here are a few of those:
Junction-Box Electronics 2 errors 002031: VSM_EVENT_VEHICLESTATE 002040: PDC: Reset due to watchdog timeout Central Gateway Module 5 errors 101008: Non-resolvable ambiguous routing - SG not in the SVT target table 100100: Contact to FZM slave lost 100104: HW Weckgrund ZGW 100203: DM software error info warning 100204: Message monitoring: no system context signal Digital Engine Electronics 6 errors CDB804: FA-CAN, message (air conditioning request, 0x2F9): missing 190302: Tank ventilation and purge air system, fine leak: leakage greater than 0.5 mm 138701: Radiator shutter, above: upper stop detected too early 231501: Error memory entry: Send buffer full 11A401: High fuel pressure when injection is released: Pressure too low 11B401: High fuel pressure during or after the injection is released (2nd environmental condition sentence after time delay): Pressure too low Is this normal? What would be the best way of getting this resolved? The iDrive is not showing any problems and the car is running fine as well. |
Post Reply |
Bookmarks |
|
|