640D (2013) Driver Seat Issue

[Greaves]

Hi Everyone. Recently purchased a used 640D and loving it. It's got 59k on the clock and has a few issues that I was aware of when purchasing. One of them is the driver seat. The plastic bolster on the rear of the seat has fallen off, not from any sort of impact or damage as I am aware and rather just fallen off.

The whole panel has fallen off as well as a couple of little metal screws which I assume hold the material in place.

Does anyone know how I can fix this? I've attached some pictures to better show what I'm referring to.







https://ibb.co/r6SzLYT
https://ibb.co/Dtnqqqk
https://ibb.co/GV0G91j

[Opie55]

Originally Posted by Greaves

Hi Everyone. Recently purchased a used 640D and loving it. It's got 59k on the clock and has a few issues that I was aware of when purchasing. One of them is the driver seat. The plastic bolster on the rear of the seat has fallen off, not from any sort of impact or damage as I am aware and rather just fallen off.

The whole panel has fallen off as well as a couple of little metal screws which I assume hold the material in place.

Does anyone know how I can fix this? I've attached some pictures to better show what I'm referring to.







https://ibb.co/r6SzLYT
https://ibb.co/Dtnqqqk
https://ibb.co/GV0G91j

Your pictures don't help much because you don't show the back of the whole piece or the "little screws" you refer to. However, based on the small slot I see in your second picture, the piece is mostly held on by clips that slide into those slots an press into the little rectangular holes in your seat back. Do you have those? They tend to slip out of the slots and a little tape helps.