06-13-2021, 11:02 AM | #1 |
Enlisted Member
11
Rep 47
Posts |
Help With CEL
Hey guys, I recently did the BM3 and Catless DP's on my car and within about 200 miles I got a CEL, I then used Bimmerlink to see the codes and then reset them and thought maybe they would go away. Well, it came back a couple of miles after. Pulled codes again and was wondering if I could get some help.
|
06-14-2021, 10:08 PM | #2 |
Lieutenant
263
Rep 582
Posts |
Check to make sure that the grounds for the Dme's were reinstalled, it can make things go wacky,if you pull the engine cover off ,you will see the two DME's one on either side they are mounted to the cross bridge, behind the DMEs there is a stud to attach a ground ,its black wire with an eye on it I believe its a 10mm nut.
__________________
2015 M6 Gran Coupe> DME stage 3 tune back end flash>JB4 with Methanol control>Fabworx Catless downpipes>Full Meistershaft GTC exhaust 102mm GB tips>Built motor with Forged Cp Carillo Rods and Pistons > SSP spec X clutch > Stage 1 Pure Turbos>PG front mount intakes>PG charge coolers>Vorsteiner front and rear Carbon diffuser>Auto Tecknic Carbon shift paddles>3D Design aluminum pedals
|
Appreciate
0
|
06-16-2021, 08:16 AM | #3 | |
Enlisted Member
11
Rep 47
Posts |
Ok ill check than, Thank you!
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|