Alloy Wheel fitment

[A51F640d]

Hi

I have 640d gran coupe, and was wondering if these alloy wheels will fit and how much the rears would stick out.
I only thought about the offset after I had purchased them

Front 9J ET20
Rear 10.5J ET25

If any one has similar setup, pictures will be appreciated

Thanks

[Parksie11]

Ouch, These are going to be no good for your car!!!
My own wheels are Front 9J Et 35 &. Rear 10.5J ET42 & fit perfectly, your new wheels will poke out a minimum 10mm Front & 18/20 mm Rear??

[jjasonSU]

The fronts will be aggressive but can work.

The rear offset is too low. For a 10.5 wheel you need the offset to be between +35 and +40

[sixfiftyay]

Originally Posted by A51F640d

Hi

I have 640d gran coupe, and was wondering if these alloy wheels will fit and how much the rears would stick out.
I only thought about the offset after I had purchased them

Front 9J ET20
Rear 10.5J ET25

If any one has similar setup, pictures will be appreciated

Thanks

fronts will be perfectly fine. they will fit flush on the fender with no rubbing. that's what i run and even lowered on h&r springs with a 255 tire, i never rub.

the rears will poke out. you can run a stretched tire and camber it a bit to get it to fit but it's going to have some poke to it. +30 is the absolute lowest i would go with a 10.5" wheel in the rear.