09-30-2020, 07:01 PM | #1 |
New Member
2
Rep 12
Posts |
wheel specs
I dont understand much about rims.. would this config work for my 2012 650xi GC ?
Rim specs: Front: 20x9 ET 20 Hub bore: 74.1mm Rear: 20x10.5 ET 27 Hub bore: 74.1mm Bolt pattern: 5x120 |
10-04-2020, 10:09 PM | #2 |
First Lieutenant
240
Rep 331
Posts |
Not sure about hub bore. Assuming hub bore fits our cars then fronts will fit. The rear is quite aggressive and will stick out the fenders ~13mm. They can fit but that's up to you if you like how much it will stick out.
edit: I don't think the hub bore will fit our cars but you might be able to get a hubcentric ring adapter. |
Appreciate
0
|
10-04-2020, 11:47 PM | #3 |
Major General
4911
Rep 8,108
Posts |
The F chassis six series wheel hubs are 72.56mm...so you’d definitely need to use hub centric rings Because the center bore of the wheels you posted are too large.
You can run your original front & rear wheel/tire setup through the calculator at this following link to compare what the “poke” & “inset” will be for the wheel/tire setup you’re attempting to install: www.willtheyfit.com
__________________
2015 F06 650ix Gran Coupe`(Moonstone/Cohiba Brown)| 2014 F15 X5 50i MSport (Space Gray/Mocha)
Become a BMW CCA member! Click HERE to join and feel free to use my BMW CCA member #191509 as a referral. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|