Small updates, but after putting some miles on the car(about 100-200 or so) we found some things to address. Most importantly, cars and coffee runs were difficult without a cup holder so we ordered a cup holder from Patina handle...
Untitled by
Nick Wood, on Flickr
Ok, maybe not the most important thing. The last time I drove the car, I made an effort to get it up to interstate speeds(70-80) and it felt fine but the temp was a touch high. We did some investigating and notice the fan clutch was weak, and decided to just overhaul the whole cooling system.
Untitled by
Nick Wood, on Flickr
Since we had access to the condenser, it seemed like a good time to replace it.
Untitled by
Nick Wood, on Flickr
Well, we mostly had access..
Untitled by
Nick Wood, on Flickr
Untitled by
Nick Wood, on Flickr
With everything removed from the front of the engine, the oil leak issue was pretty obvious...
Untitled by
Nick Wood, on Flickr
So the cover was removed and the brittle old seal was replaced.
Untitled by
Nick Wood, on Flickr
As of now, we are just waiting on parts. All new coolant hoses, belts, Ac condenser, parts for ac lines(we arent getting it going at this time but just to a point where it wont have to be torn down again when we do), water pump, timing chain tensioner, etc etc. I am sure I am forgetting some parts. While is down we figure it would be a good time for a valve adjustment.
Untitled by
Nick Wood, on Flickr
We will also give the engine a good steam cleaning but we should have a leak free(by bmw standards) properly cooled engine when it is all said and done.
On a more fun note, the floor mats came in over the weekend. I am very impressed with the fit and finish of these Cocomats, I will probably order some for my other cars.
Untitled by
Nick Wood, on Flickr