[RagtagXMASTER]

So i had the opportunity to get a set of original blue carbon fiber intakes made by Eventuri. sadly they were scratched a little, so i decided to refinish them

A lot was learned through this process. The intakes are well made, they used a nice thick epoxy, but it yellows from engine bay heat. at least the blue epoxy does. these tubes were actually the same standard black carbon fiber, but covered in a blue tinted epoxy!, this really makes any possibility possible for carbon finishes!

Here are some pictures of the refinishing process! I will also put up finished pictures once i complete the MAF tubes, i am currently trying to get the yellowing out of the CF, proving to be a very difficult process. Final option will be hydro dipping the tubes.