11-13-2018, 06:47 PM
|
#7
|
Drives: F80 M3 6MT
Join Date: Nov 2015
Location: Vista, CA
|
Quote:
Originally Posted by Knightro_Circus
Even at the center hub where the spoke pieces are attached? If so, could the same idea be applied to aluminum where you wouldn't have to start with 100lbs blocks for each wheel? Or is this a byproduct of using titanium in this product? Just asking out of curiosity.
|
You could print in aluminum if you'd like, absolutely. In this instance rather than taking a billet forging then machining away all the bits we don't want, it's an additive process where we're doing almost the complete opposite, creating only the pieces that we actually use, rather than machining away the bits we don't.
|
|
|