[MARKPRIOR]

Originally Posted by Havy

Hey Mark,
That looks awesome. Congratulations well done. And this time square pants was not involved

lol yeah, the most fiddly bit of the job was my fat fingers disconnecting the speaker wires from the back shelf

looking at the guide thread, noted below

Originally Posted by jjasonSU

here you go
DIY Guide - H&R Springs on 650i xDrive Gran Coupe
by board57796

there were a few things i didnt need to do, separate the top wishbone etc... im just assuming this was because the car used had 4wd and maybe drive shaft was in the way. i managed to get them out but standing on the hub with the other pulling the damper from the bottom easy enough, also did not need to unscrew any bolt in the boot lid. the guide was a great help though and likley saved me hours of fiddleing with stuff.... top marks to the poster



oh before i forget, ride review.....

the ride is not to much different from stock, if i had to describe it 10% stiffer on bumps etc... but a good 60-70% less body roll