How do you guys put 4inch tips on u r m5 or m6 mufflers? i measure less than an inch gap between the 2 tips, the factory tips are 3inches, so if i wanted 4 inch tips i would require 1inch gap between no? (.5 per tip)
also in an other thread
https://www.6post.com/forums/showthr...7#post24654457 the op mentioned that most tips are 9 inches long therefore some cutting may be required, can someone elaborate on that?
these are the tips I was planning on getting:
akrapovic replica
and how do i remove the stock tips? just pull em off? any tips?