Quote:
Originally Posted by m6NYC
Which did end up going with the CSF Intercoolers? Also would you mind sharing some pics of your meth setup? Im about to reinstall my system as well on my vsrf intercoolers and I'm looking for neater installs.
|
I kept that stock IC, but I used 50/50 meth spraying at the charge pipe.
Controller is by Torqbyte (CM5 - LTS) , BMS pump & Aquamist nozzles.
Bm3 Stage 2 93OCT
Datalog with WMI
https://www.bootmod3.net/log?id=5f1e...729b74ba722514
Will share some pics after work.
Update
Here are some photo of my setup.
I installed the controller, pump & tank in the trunk.
Moved the wires & hose from the trunk to front of the engine.
I tapped into the manifold pressure sensor rather than the throttle body pressure sensor, the only advantage is usually when you shift or release the throttle TMAP overboost (in my case 30+ PSI) while the throttle is almost close causing the controller to continue signalling the pump to spray.