6Post.com | BMW 6-Series Forum - View Single Post

Beastman · 08-31-2020, 02:17 PM

Hi
looking for advice on fitting AC Schnitzer Type 4 alloys onto my 2013 640d GC. Always loved these wheels and have found set fronts 20x9 et42 rears 20x10 et33 or set from an E65 being 21" same widths and offset.

I imagine I'll need front spacers and wondered about best tyre size/aspect ratio and run flat or not? Only downside is apparently my TPMS sensor dont fit these wheels so would need it coded out.

TIA

08-31-2020, 02:17 PM	#1
Beastman Registered 0 Rep 2 Posts Drives: BMW 640d GC Join Date: Aug 2020 Location: Bonnie Scotland iTrader: (0)	AC Schnitzer Type IV Alloys Hi looking for advice on fitting AC Schnitzer Type 4 alloys onto my 2013 640d GC. Always loved these wheels and have found set fronts 20x9 et42 rears 20x10 et33 or set from an E65 being 21" same widths and offset. I imagine I'll need front spacers and wondered about best tyre size/aspect ratio and run flat or not? Only downside is apparently my TPMS sensor dont fit these wheels so would need it coded out. TIA
	Appreciate 0 Tweet Quote