View Single Post
      08-10-2020, 11:43 PM   #11
Private First Class

Drives: '14 M6GC
Join Date: Apr 2018
Location: Bahrain

iTrader: (0)

Originally Posted by m6NYC View Post
Which did end up going with the CSF Intercoolers? Also would you mind sharing some pics of your meth setup? Im about to reinstall my system as well on my vsrf intercoolers and I'm looking for neater installs.
I kept that stock IC, but I used 50/50 meth spraying at the charge pipe.

Controller is by Torqbyte (CM5 - LTS) , BMS pump & Aquamist nozzles.

Bm3 Stage 2 93OCT

Datalog with WMI

Will share some pics after work.


Here are some photo of my setup.

I installed the controller, pump & tank in the trunk.

Moved the wires & hose from the trunk to front of the engine.

I tapped into the manifold pressure sensor rather than the throttle body pressure sensor, the only advantage is usually when you shift or release the throttle TMAP overboost (in my case 30+ PSI) while the throttle is almost close causing the controller to continue signalling the pump to spray.
Attached Images

Last edited by M6Roar; 08-12-2020 at 05:39 AM..
Appreciate 1