Quote:
Originally Posted by vaio23
Got mine installed, just get some m7-1 50mm hex bolts from home depot. I used three per side (each end and center) for the rest of the holes I just used the supplied hardware to hold the blade to the skirt. You will need to remove the nuts underneath the car at these locations. Also test fit my rear diffuser, need to adjust my exhaust because of fitment issues  |
Looks good!
We use the same bolts, because we also found the Vorsteiner screws to be a bit on the short side...
However, we used 4 per side in addition to the double sided tape, just as a precaution
