Quote:
Originally Posted by Opie55
Is it locked because it is so tight you cannot put slack in it? In any event, before I ordered anything or took it anywhere I would disassemble as much as I need to to get to the bolt that holds the one end on the lower outside of the seat. That can't be much more than a 10 minute job. The bolt will either be a large Torx or maybe even a triple square, so if you question your skills or your tool supply, take it to a trusted indy shop and suggest they try that. Once you unwrap it it may work again. The instructions will be on the NewTis site.
|
It was giving about a half inch of slack before the dealership looked at it, but now it’s completely tight and doesn’t give up anything since they gave it back. I will try to get that bolt undone. You’re thinking the belt should release as soon as I undo that bolt?