Quote:
Originally Posted by nwills
Did you put a screw through the exhaust pipe to block the flap open? Wouldn't that make a hole in the exhaust?
I tried blocking the rubber pipe but the flaps remained closed!
|
From the technical drawing, the actuator is right on the exhaust. If you can unhook it and zip tie the link/arm that control the flap, then that should do the trick. However, I think the flap does more than just the sound but also control the back pressure. If you keep it open all the time the torque might be affected a bit. Probably not too bad since it got a lot to spare to begin with. I will try to look into it next weekend unless you get it working and wanna share some photos before that.