Quote:
Originally Posted by JoeyLeeBMW
I will be dynoing my car again at EAS to compare it against my stock base line dyno chart.
See the thing is with these piggyback units the hp + torque numbers are all over the place being inconsistent.
579 to 622 is a 43 hp in power difference not only that the torque going from 520 to 576 alone is a 56 lb difference and that was shown on not even the highest hp read.
Karim try next time with full MS109 Octane from VP Fuel you get from a 5 gallon can like I did.
Are you also running the older software before March 3rd release or new?
The older software 1 psi over = 1.44 just so you know.
So when I did my dyno run on MS109 I was at 4.5 max which equivalents to 6.48 lol *DOH*
|
I use older BMS firmware, so 2.5 is fine. New update changes the value, +3psi on the new one = +2.5 on the older one.